Muusikoiden.net - Keskustelu | |
Kirjoittaja: | 73nd3r |
Alue: | Kitarat: kitarakamat |
Aihe: | Putkivahvistimen tehoista ja impedansseista |
Aika: | 17.05.2020 10:08 |
hannu matti: Heii..kyseessä VOX VT40 ..pystyykö tehdyt soundit resetoimaan tehdas asetuksiin . Miten ?? Ohjekirja VT(XX)+ malleille neuvoo näin: "Restoring the factory settings Heres how to restore all settings of the VT20+/VT40+/VT80+/VT120+ to their factory-set state. NOTE: This operation will erase all programs that had been saved to channels, and will initialize the factory-set programs. NOTE: This will also initialize the effect and noise reduction settings that you made in Manual mode. 1. Turn off the power. 2. While holding down the CH1 and CH4 switches, turn on the power. When the BANK and CHANNEL LEDs start blinking, release the two switches you had been holding down. HINT: If you decide to cancel initialization at this point, press the TUNER (BYPASS) switch. 3. Press the TAP switch. The BANK and CHANNEL LEDs will change from blinking to lit, and initialization will begin. In one or two seconds, initialization will be completed, and the unit will enter Preset mode. NOTE: Never turn off the power while initialization is in progress." | |
Copyright ©1999-2024, Muusikoiden Net ry. Kaikki oikeudet pidätetään. https://muusikoiden.net/keskustelu/posts.php?c=15&t=37290 |